• From: NIT SILCHAR
  • Registered: 2016-03-22
  • Posts: 14

Topic: Modelling problem

Sir,i want to make a steel plate,through which reinforcement bars are to be  placed,so is it possible to design in ATENA. If possible can you explain it.Otherwise i will send you my model.
Regards
Prasenjit saha
NIT SILCHAR

Quote Post 1

  • dpryl
  • CC software developer
  • Offline
  • Registered: 2007-07-13
  • Posts: 1,107

Re: Modelling problem

Dear parimals,
if you wish help with your modelling, send above all a sketch/photo + description of the real setup and the questions to be answered through the analysis.

Just guessing: you may be interested in reading ATENA Troubleshooting, 2.2.12 How can I model a pull-out experiment?

Regards.

dpryl's Website

Quote Post 2