<![CDATA[Cervenka Consulting Forums — Graph definition]]> https://forums.cervenka.cz/viewtopic.php?id=145 Fri, 25 Mar 2011 10:29:27 +0000 PunBB <![CDATA[Re: Graph definition]]> https://forums.cervenka.cz/viewtopic.php?pid=405#p405 Yes, this is normal, the monitors appear in the list after the first iteration is complete.

]]> Fri, 25 Mar 2011 10:29:27 +0000 https://forums.cervenka.cz/viewtopic.php?pid=405#p405 <![CDATA[Graph definition]]> https://forums.cervenka.cz/viewtopic.php?pid=403#p403 Hello...

I'm studing the punching phenomenon in a flat slabs by numerical investigation.

After I did the model on Atena3D I starts to run the analysis, but, by following your tutorial, I can't define the graph parameters before start to calculate the analysis.

It appears that information: "No monitors are available - it is not possible to define graph parameters...". However, I introduced the "Monitoring Points"  in the model.

When I start to run the analysis is allready possible to change the graph parameters.

Is this normal or did I do something wrong?

Thanks for Your Attention,
Regards,
NM

]]> Thu, 24 Mar 2011 19:50:10 +0000 https://forums.cervenka.cz/viewtopic.php?pid=403#p403