<![CDATA[Cervenka Consulting Forums — Geometric Nonlinearity]]> 2014-04-04T11:19:41Z PunBB https://forums.cervenka.cz/viewtopic.php?id=1714 <![CDATA[Re: Geometric Nonlinearity]]> A short answer: yes.

A more detailed one: in General data - Analysis information - Solution you can check/uncheck a box named "Geometrically nonlinear analysis". If enabled, the equilibrum on deformed geometry is considered even during each iteration. If disabled, the geometry from the end of the previous load step is used during the iterations.

]]> https://forums.cervenka.cz/profile.php?id=4 2014-04-04T11:19:41Z https://forums.cervenka.cz/viewtopic.php?pid=3134#p3134 <![CDATA[Geometric Nonlinearity]]> Hello,

i would like to ask, the program ATENA 3D take into consideration the geometric nonlinearity in addition to material nonlinearity?

Thanks

]]> https://forums.cervenka.cz/profile.php?id=24797 2014-04-04T09:30:37Z https://forums.cervenka.cz/viewtopic.php?pid=3133#p3133