Cervenka Consulting Forums — Internal error running model on Atena 3D Engineering

Re: Internal error running model on Atena 3D Engineering

2014-05-26T10:49:49Z

Dear rpereirapainco,
please see ATENA Troubleshooting, 2.4.6 Floating point problems - Division by zero, Loss of >7 digits on the matrix diagonal, Warning: Sign of diagonal changed when reducing equation, Floating point exception: Multiple floating points traps, Zero or negative jacobian, InvertA: zero determinant, CCMaterials Extended AExc: CC5ParamYield F: project_stress_on_f_division by zero, and similar.
The latest version of the document is available from our web under Products - ATENA - Documentation.

Internal error running model on Atena 3D Engineering

2014-05-26T10:03:10Z

Dear User/Admin.,

I'm using Atena 3D Engineering to model a push-out test. When I run the model it can converge on step 1 and 2 but on the third step it stop and open up a window with the following message "CCMaterialExtendedAExc: CC5ParamYieldF::project_stress_on_f - division by zero". I don't know what could be wrong neither what it means.

If someone could help me I would appreciate it very much.

Thanks in advance,

Raquel Painço