I made a model for a Simply Supported Reinforced Concrete Beam Using ATENA (v 5.0.3.0)
-beam section is 30 cm x70cm (width x height)
-two macro elements was used to model the beam ,the lower part its height = 5cm and include smeared reinforcement and the upper part its height = 65cm

(1) for the ratio(p=As/Ac) of Smeared Reinforcement,is (Ac) equal 30 cm x 5 cm or 30 cmx70cm ?

(2)Referred to (ATENA-Engineering-2D_Users_manual) section (4.4.3.4 Smeared Reinforcement)

[The field ‘Ratio’ should be filled with the value of reinforcing ratio p=As/Ac (where As is the reinforcement cross section area and Ac is the concrete cross section area)].

Is (As)  mean  the total area of required reinforcement as known by codes or the reinforcement cross section as written ?