<![CDATA[Cervenka Consulting Forums — multiple thread exception error message]]> 2016-09-15T10:55:14Z PunBB https://forums.cervenka.cz/viewtopic.php?id=1873 <![CDATA[Re: multiple thread exception error message]]> Dear thiyagartr,
it is not clear from your question if you have already read ATENA Troubleshooting, 2.2.12 How can I model a pull-out experiment? and 2.4.6 Floating point problems - Division by zero, Loss of >7 digits on the matrix diagonal, CCFEModelExc: CCPardiso solver error: zero pivot,  Warning: Sign of diagonal changed when reducing equation, Floating point exception: Multiple floating points traps, Zero or negative jacobian,  InvertA: zero determinant, CCMaterials Extended AExc: CC5ParamYield F: project_stress_on_f_division by zero, and similar.

You might also be interested in 2.4.2 I get the message "The execution is killed due to violation of stop iteration criteria", what does it mean?, 2.1.19 Problems reaching convergence and understanding ATENA convergence parameters, and 2.2.22 How to detect a structural collapse or ultimate load capacity.

If you can not solve the problems, please follow Troubleshooting, 2.1.1 to send us your model etc.

Regards.

]]> https://forums.cervenka.cz/profile.php?id=4 2016-09-15T10:55:14Z https://forums.cervenka.cz/viewtopic.php?pid=3568#p3568 <![CDATA[multiple thread exception error message]]> I'm trying to simulate pullout behaviour of adhesive anchor in concrete. the analysis is  running to 13th step with 0.02mm as deformation for each step and then suddenly stops at 14th step. with an error message, " multiple thead exceptions occurred 1 time" I'm using sbeta material for concrete and elastic isometric for anchor and also I wanna know the material for epoxy adhesive.
Thank you

]]> https://forums.cervenka.cz/profile.php?id=25200 2016-09-15T08:57:22Z https://forums.cervenka.cz/viewtopic.php?pid=3567#p3567