<![CDATA[Cervenka Consulting Forums — modelling a GFRP bar RC beam]]> 2016-11-14T08:58:22Z PunBB https://forums.cervenka.cz/viewtopic.php?id=1888 <![CDATA[Re: modelling a GFRP bar RC beam]]> Dear asfeiza,
I assume you have already read ATENA Troubleshooting, 2.2.18 My analysis results do not match the experiment/expectations. How can I improve my model? 

If you wish help with your particular modelling, please follow Troubleshooting, 2.1.1 to send us your model, a graph comparing the measured and calculated Load-Displacement curves, etc.

Regards.

]]> https://forums.cervenka.cz/profile.php?id=4 2016-11-14T08:58:22Z https://forums.cervenka.cz/viewtopic.php?pid=3616#p3616 <![CDATA[modelling a GFRP bar RC beam]]> hello,

i have done modelling the GFRP bar RC beam, but unfortunetly i didn't get a good graph and can not validated same as my experiment. i also do the modelling RC by using steel bar, and i get the same trend as my experiment. i have compare my atena modelling with other finite element, but for my modelling GFRP bar RC beam, it not give a good trend, and the load smaller then experimental. what should i do? I have model GFRP bar same as i Model the Steel.  I pick Linear type for modelling GFRP bar in reinforcement material. tq

]]> https://forums.cervenka.cz/profile.php?id=15374 2016-11-12T01:20:20Z https://forums.cervenka.cz/viewtopic.php?pid=3612#p3612