Cervenka Consulting Forums — ATENA 3D Error Load Reading

Re: ATENA 3D Error Load Reading

2017-04-27T14:36:13Z

Hello,

sorry, i dont understand very well what is the problem.

Can you send me your model with the problem to the email? and described which value is incorect

Thanks

Re: ATENA 3D Error Load Reading

2017-04-26T15:02:31Z

Hi,

Thank you I solved that problem, it was about boundary condition, I have another question I have a RC beam with 4 point loads when model only half of the beam because of symmetry I have 2 point loads, I did model 2 steel plates for the load but only one of them is giving +ve value the other open is -ve and the value for both should be the same but in ATENA 3D is not, how can I model 2 point loads or more?

Thank you

Re: ATENA 3D Error Load Reading

2017-04-26T12:56:58Z

Hello,

probably bad boundary conditions and bad parameters in monitors...

Please send us your model by email.

Zdenek

ATENA 3D Error Load Reading

2017-04-25T21:35:56Z

Hello,

I'm getting the below error message when I run the program for each steps:

(*) Warning: Loss of at least 7 digits in reducing diagonal of equation: 12946, (node: 1016, dof_id: 2); value: 536.257.
(*) Monitor U2 - Load: error reading value.
(*) Monitor U3 - Load: error reading value.

Any Ideas?

Thank you