Cervenka Consulting Forums — Setting Interval Data for Prescribed Displacement

Re: Setting Interval Data for Prescribed Displacement

null@example.com (pavlo) — Sun, 08 Dec 2019 12:11:56 +0000

Rizky,

I haven't received any email... Could you send a link to fileshare in private message at the forum?

Re: Setting Interval Data for Prescribed Displacement

null@example.com (rizkytriamalia20) — Mon, 02 Dec 2019 01:15:29 +0000

With my pleasure.
I already sent email to you sir.

Re: Setting Interval Data for Prescribed Displacement

null@example.com (pavlo) — Sun, 01 Dec 2019 11:47:21 +0000

Hi Rizky,
Could you share you model please? It would be easier to answer your question with the model.

Setting Interval Data for Prescribed Displacement

null@example.com (rizkytriamalia20) — Sun, 01 Dec 2019 01:25:26 +0000

Hello my name is rizky i'm using ATENA Studio from GID. Sir, i have a double curvature column (column with two stub at the top and the bottom) model, and i have to set the displacement at the bottom stub with 0.072 m displacement.

I tried to put displacement for surface at the side of stub with value=0.0036 mm and i adjust the multiplier (in interval data)=20, also i divide this into 10 step. But, from the monitoring point until the analysis are complete the displacement only show 0.056 m.

Am i right that to reach 0.072 mm displacement at the end of analysis is put the displacement for surface=0.0036 mm and adjust multiplier 20?
Or any other way to reach this?
Thank you very much for your help.