Cervenka Consulting Forums — Changing Reinforcement bars properties

Re: Changing Reinforcement bars properties

2020-06-29T09:27:27Z

Dear dpryl,

Thank you for your very useful feedback. Yes, this is exactly what I am looking for.

Massive thanks.

dpryl wrote:

Dear msmeleven,
just and additional note: in ATENA Engineering 3D, it is also possible to replace reinforcement or reinforcement bond material with another through Topology - Reinforcement bars - Selected - Edit.
Regards.

Re: Changing Reinforcement bars properties

2020-06-29T09:25:42Z

Thank you for your reply.

pavlo wrote:

If you have a unique bond type then all you need to do is to change Bond material in "Materials". Hence, it will be updated for all bars with this specific bond type.
Besides, it would be more difficult if you use ATENA Science but in ATENA 3D it is quite simple.

Re: Changing Reinforcement bars properties

2020-06-29T08:31:48Z

Dear msmeleven,
just and additional note: in ATENA Engineering 3D, it is also possible to replace reinforcement or reinforcement bond material with another through Topology - Reinforcement bars - Selected - Edit.

Regards.

Re: Changing Reinforcement bars properties

2020-06-28T14:13:40Z

If you have a unique bond type then all you need to do is to change Bond material in "Materials". Hence, it will be updated for all bars with this specific bond type.

Besides, it would be more difficult if you use ATENA Science but in ATENA 3D it is quite simple.

Changing Reinforcement bars properties

2020-06-28T11:48:06Z

Hello,

I am using ATENA 3D to do parametric study.

I have 60 reinforcement bars with a bond material. I want to replace the current bond material with another one.

Is there any way to change bond material for all reinforcement bars at once? instead of changing the properties to each bar individually or erasing the current bars and create new bars.

Thank you.