<![CDATA[Cervenka Consulting Forums — Warning: Redundant (needless) LHS BCs detected]]> 2011-09-12T08:02:08Z PunBB https://forums.cervenka.cz/viewtopic.php?id=232 <![CDATA[Re: Warning: Redundant (needless) LHS BCs detected]]> This warning is a result of applying supports in a direction to nodes that are already held in that direction by other means. Typically, this occurs at supports applied to macroelements connected through master-slave connections (e.g., 2 blocks next to each other, supported from bottom), or when shells are supported in a direction not perpendicular to their thickness (then, the implicit master-slave in depth direction and the support act in the same direction).

A boundary conditions' conflict can also occur on a line (point) shared by 2 surfaces (lines) with boundary conditions applied. In that situation, you may need to apply the combined condition explicitely to the line (point), if the 2 conditions are not identical.

]]> https://forums.cervenka.cz/profile.php?id=4 2011-09-12T08:02:08Z https://forums.cervenka.cz/viewtopic.php?pid=606#p606 <![CDATA[Warning: Redundant (needless) LHS BCs detected]]> Hello,

During calculation I get the warning: Redundant (needless) LHS BCs detected for th following u (node_id,do_id):
they will be ignored. (Source line: 1015, file: ...
0 0.10E+01! (ISSCG)

...and further ...


Will this give problems?

Regards,
Evert

]]> https://forums.cervenka.cz/profile.php?id=6081 2011-09-09T09:50:01Z https://forums.cervenka.cz/viewtopic.php?pid=603#p603