Cervenka Consulting Forums — Arc &Circles

Re: Arc &Circles

null@example.com (dpryl) — Mon, 22 Oct 2012 08:09:31 +0000

Hello, I assume you work in ATENA Engineering 3D. Arcs are defined in working plane. Therefore, after you open the Macroelement creation/edit dialog, please first select your working plane and offset through the "Dialogue window for working plane and grid configuration" icon and the offset left of the icon.

Arc &Circles

null@example.com (ssaber) — Fri, 19 Oct 2012 14:28:17 +0000

Hello.
for Create an arc I get following error :

Arc & circle parameters
Definition arc byÂ center beg. (0.0570; 0.0000; 0.0570), end (0.0000; 0.0000; 0.0000), center (0.0570; 0.0000; 0.0000), orientation positive
Division by angle every 10.00 Â°

The center of the arc is not between the first and last point!

how remove this problem.
tank you so much.