<![CDATA[Cervenka Consulting Forums — Atena: RC frame with monothonically increasing cyclic lateral load]]> 2009-11-04T10:21:02Z PunBB https://forums.cervenka.cz/viewtopic.php?id=66 <![CDATA[Re: Atena: RC frame with monothonically increasing cyclic lateral load]]> That should be no problem - you simply define 2 load cases, one for each direction. Do not forget to also define 2 monitoring points for the 2 reactions (in case of prescribed displacements) or forces (in case of force loading).

When creating the load steps, you apply the supports + thew first of the loading cases in several steps, followed by the same number of steps with a negative multiplier. Then, you apply the other load case in the same way.

]]> https://forums.cervenka.cz/profile.php?id=4 2009-11-04T10:21:02Z https://forums.cervenka.cz/viewtopic.php?pid=130#p130 <![CDATA[Atena: RC frame with monothonically increasing cyclic lateral load]]> How can i model cyclic load behaviour if i have two distinct points where the load is applied to the frame (left and the right end of a beam)? First the load is acting from the left side and returns to zero. After that to the same level a load from the right is applied.

Thank you very much!

]]> https://forums.cervenka.cz/profile.php?id=237 2009-11-03T15:55:49Z https://forums.cervenka.cz/viewtopic.php?pid=129#p129