<![CDATA[Cervenka Consulting Forums — mesh to contact surface]]> 2010-04-26T11:47:20Z PunBB https://forums.cervenka.cz/viewtopic.php?id=97 <![CDATA[Re: mesh to contact surface]]> Dear prof. Parikh,
I am not sure what you wish to do - the default contact setting is "Perfect connection". In that case, there are no elements created for the contact, the nodes of the 2 surfaces of the adjacent volumes are connected using Master-Slave connections.

Only if an interface (GAP) material is applied to the contact, mesh is created for the contact.

The word "partial" describes a contact between 2 surfaces where one is smaller than the other or which only overlap partially. It has nothing to do with the connection type / interface material.

]]> https://forums.cervenka.cz/profile.php?id=4 2010-04-26T11:47:20Z https://forums.cervenka.cz/viewtopic.php?pid=227#p227 <![CDATA[mesh to contact surface]]> dear sir,
How to apply mesh to contact surface, because surface shows 'partial' hece error massage comes. To carry out full contact between concrete and FRP sheet, what I have to do , so that I can generate mesh in the interface.

]]> https://forums.cervenka.cz/profile.php?id=279 2010-04-24T12:51:51Z https://forums.cervenka.cz/viewtopic.php?pid=220#p220