• Registered: 2016-05-13
  • Posts: 1

Topic: Reactions on Line Support

Hi!
I'm new to Atena.
I modeled slab and want to monitor the line supports. I get results for singel nodes and single monitor points. Since the slab gets diffrent vertical reactions in every supported node I'd have to set a lot of monitoring points...
Is there a way to monitor the (over all) vertical reacions per meter or any other scale?

Quote Post 1

  • dpryl
  • CC software developer
  • Offline
  • Registered: 2007-07-13
  • Posts: 1,107

Re: Reactions on Line Support

Dear taniels, please see ATENA Troubleshooting, 2.2.19 How can I monitor a surface (or line) load?
Regards.

dpryl's Website

Quote Post 2