Topic: Setting Interval Data for Prescribed Displacement
Hello my name is rizky i'm using ATENA Studio from GID. Sir, i have a double curvature column (column with two stub at the top and the bottom) model, and i have to set the displacement at the bottom stub with 0.072 m displacement.
I tried to put displacement for surface at the side of stub with value=0.0036 mm and i adjust the multiplier (in interval data)=20, also i divide this into 10 step. But, from the monitoring point until the analysis are complete the displacement only show 0.056 m.
Am i right that to reach 0.072 mm displacement at the end of analysis is put the displacement for surface=0.0036 mm and adjust multiplier 20?
Or any other way to reach this?
Thank you very much for your help.