Back to company website

You are not logged in. Please login or register.

Forum updated

We have recently updated our forums system, and we have cleared all spam topics and users. In case we accidentally deleted your account, please register again. If you miss a topic you have posted before, please let us know.

Post new reply

Cervenka Consulting Forums → ATENA → Unstructured Mesh → Post new reply

Post new reply

Compose and post your new reply

You may use: BBCode Smilies

All fields with bold label must be completed before the form is submitted.

Required information for guests


Required information

Topic review (newest first)

3 Post by yamancivil

Thanks a lot for replay,
The reason for asking is we are using the demo version and
some times the software give us a message regarding the number of the nodes
and we want to check if we followed the right procedure and thanks a gain.

2 Post by dpryl

Dear yamancivil, yes, this is how to assign unstructured mesh sizes in GiD. Is there a specific reason why you ask about it?

1 Post by yamancivil

Hi there...
Kindly , when a column have plates above and under it.

In case of unstructured mesh inorder to assign different element sizes , is this the right procedure for doing that?:-

Mesh > Unstructured > Assign sizes on Volumnes>

then we will have  a new window (Enter size to assign to volumes)

and for example enter 0.09 (i.e large elements for plates (Master)) and Assign for the top and bottom plates then ESC and

then the same window will appear (Enter size to assign to volumes)

for example enter 0.03 (i.e small elements for column (Slave)) and Assign for the column then ESC then Close.

Then Mesh > Generate Mesh.... or please it means we did a mistake? so please any feedback with our Kind regards.

Cervenka Consulting Forums → ATENA → Unstructured Mesh → Post new reply