Back to company website

You are not logged in. Please login or register.

Forum updated

We have recently updated our forums system, and we have cleared all spam topics and users. In case we accidentally deleted your account, please register again. If you miss a topic you have posted before, please let us know.

Post new reply

Post new reply

Compose and post your new reply

You may use: BBCode Smilies

All fields with bold label must be completed before the form is submitted.

Required information for guests


Required information

Topic review (newest first)

3 Post by mdp198

Thanks for the upgrade.  It worked as expected and I was able to just add a new segment of reinforcement.  That therefore negates, my second question.

Also, I did send an email with file attached for some support, can you tell me if it might have arrived and been looked at yet?  It was regarding adding a opening into a concrete block, and then adding a steel plate into the opening.  An embedded plate.  I could not get past forming the opening.  I had sent to cervenka@cervenka.cz.  Will be happy to resend if needed.

Thanks again,

Matt

2 Post by dpryl

This problem should be solved in the latest ATENA version - 4.2.6 release candidate. The upgrade installer for all users with a valid maintenance is available for download from http://www.cervenka.cz/downloads

I am not sure if I understand the second question - arcs are replaced by straight segments in ATENA 3D (the number of segments is set at the time of adding the arc). Just delete the segments that should be replaced, and define the new arc instead.

1 Post by mdp198

Hello:

I wonder if you might be able to shed some light on why I have been receiving an error when trying to place additional reinforcement, in an existing model in Atena 3D.  I get the error "List index out of bounds".  I have tried and replicated this on past trial runs of the same model, as well as in different location in my model. The only time today when I have not had the error was when starting a completely new file as a test.

Also, a second question...If one has a reinforcement bar with several segments (say 3), is it possible to increase the diameter of one of those segments (say segment #1 of 3)?  This would be aimed at replicating an embedded anchor bolt and nut. 

Thank you so much