Dear FadiAwed,
please see ATENA Troubleshooting, 3.3.2 Problem creating an opening (More than two surfaces are connected to the edge n.XX!) for general advice related to openings. If you still can not create the geometry needed, please send us your model (see also Troubleshooting, 2.1.1) along with screenshots illustrating your steps + the messages.
You are not logged in. Please login or register.
Forum updated
We have recently updated our forums system, and we have cleared all spam topics and users. In case we accidentally deleted your account, please register again. If you miss a topic you have posted before, please let us know.
Post new reply
Cervenka Consulting Forums → ATENA → Problems with openings → Post new reply
Compose and post your new reply
All fields with bold label must be completed before the form is submitted.
Topic review (newest first)
Dear sir,
the following sequence of steps is described to form an opening:
1)The lines are entered by using tools for input of joints and lines
2)The macroelement without opening is defined using the macroelement input tools.
3)The openings are entered by choosing the tool for opening and selecting all lines forming
each opening.
when Ii tried that, I had this message: " A macro-element with identical topology already exists."
what have I done wrong?
Cervenka Consulting Forums → ATENA → Problems with openings → Post new reply
Powered by PunBB, supported by Informer Technologies, Inc.