You are not logged in. Please login or register.
Active topics Unanswered topics
Forum updated
We have recently updated our forums system, and we have cleared all spam topics and users. In case we accidentally deleted your account, please register again. If you miss a topic you have posted before, please let us know.
Post new reply
Post new reply
Compose and post your new reply
You may use: BBCode Smilies
All fields with bold label must be completed before the form is submitted.
Topic review (newest first)
Dear MuhendisAus,
it is not clear from your question if you have already read ATENA-GiD User's, 5.3.6 Interface Material?
I don't get from your sketch not the text what is the circle - I thought that is just marking a plan blow-out picture, but then talking about an unintended gap maked no sense?
If you wish advice on modelling your geometry, I suggest you first explain what you are modelling and what is the purpose/target of your analysis (including sketches/photos, see also Troubleshooting, 2.1.1).
Regards.
Hi,
I have been learning how to use GiD and Atena recently and I have now faced my first problem. I was hoping someone could take a look and advise:
1. I have two parts, a blue part and a green part.
2. The green part bites in the blue part as the green part is pulled (in real life).
3. I can model the components of the blue section but when I to create the outer diameter I obtain a gap (red).
How do I eliminate this gap and create a section that fits the inside green part?
Here is a link to the image:
https://s15.postimg.org/u0ulu5j8r/finite.jpg
Regards,
MuhendisAus
