Back to company website

You are not logged in. Please login or register.

Forum updated

We have recently updated our forums system, and we have cleared all spam topics and users. In case we accidentally deleted your account, please register again. If you miss a topic you have posted before, please let us know.

Post new reply

Post new reply

Compose and post your new reply

You may use: BBCode Smilies

All fields with bold label must be completed before the form is submitted.

Required information for guests


Required information

Topic review (newest first)

4 Post by zjanda

Hello,

sorry, i dont understand very well what is the problem.

Can you send me your model with the problem to the email? and described which value is incorect

Thanks

3 Post by mshwani

Hi,

Thank you I solved that problem, it was about boundary condition, I have another question I have a RC beam with 4 point loads when model only half of the beam because of symmetry I have 2 point loads, I did model 2 steel plates for the load but only one of them is giving +ve value the other open is -ve and the value for both should be the same but in ATENA 3D is not, how can I model 2 point loads or more?

Thank you

2 Post by zjanda

Hello,

probably bad boundary conditions and bad parameters in monitors...

Please send us your model by email.

Zdenek

1 Post by mshwani

Hello,

I'm getting the below error message when I run the program for each steps:

(*)    Warning: Loss of at least 7 digits in reducing diagonal of equation: 12946, (node: 1016, dof_id: 2); value: 536.257.
(*)    Monitor U2 - Load: error reading value.
(*)    Monitor U3 - Load: error reading value.

Any Ideas?

Thank you