Back to company website

You are not logged in. Please login or register.

Forum updated

We have recently updated our forums system, and we have cleared all spam topics and users. In case we accidentally deleted your account, please register again. If you miss a topic you have posted before, please let us know.

Post new reply

Cervenka Consulting Forums → ATENA → Error reading value → Post new reply

Post new reply

Compose and post your new reply

You may use: BBCode Smilies

All fields with bold label must be completed before the form is submitted.

Required information for guests


Required information

Topic review (newest first)

8 Post by crazylisa

Thanks a lot smile

The email has landed in the Spam folder. I did not think about that.

7 Post by dpryl

2 Lisa: Please see my email answer from Sep 6th, 16:03.

2 Rukiye: Please make sure you indeed have the right monitor defined (External Forces in case of force loading, Reaction in case of prescribed displacements) and that it is located in the same point as your load.

If you still can not identify the problem source, you can send us your model etc., following Troubleshooting, 2.1.1.

Regards.

6 Post by rukiye.tuncer1

Hello dear Sir or Madame,

I've got the same problem with reading the Monitorinpoints. I've modelled a two span post tensioned concrete beam. Everything is working fine till the last step. ATENA gives me the displacements but not the reaction to the prescribed deformation. And i already read the troubleshooting. Everything is just how it has to be.
Can you please help me fixing the problem.

Thanks in advance!

Rukiye

5 Post by crazylisa

I send you an email last week with my model but got no answer yet.
I´m not sure if I send it to the right email adress. Do you have a personal email adress?

Many thanks in advance
Lisa smile

4 Post by dpryl

If you still can not identify the problem source, you can send us your model etc., following Troubleshooting, 2.1.1.

3 Post by crazylisa

I already see ATENA Troubleshooting 2.1.13 but I can`t fix the problem with the monitoring point.

Regards
Lisa

2 Post by dpryl

Dear Lisa,
for the most frequent sources of this problem, please see ATENA Troubleshooting, 2.1.13 A monitoring point shows no value, the program gives me an error on reading a monitor value.
Regards.

1 Post by crazylisa

Hello,

I also want to build up a Pull-Out-Test. I'm getting the below error message when I run the program for each steps:

(*)    Monitor U2 - Load: error reading value.

But the calculation is continue. I don't know why. So,I think I need your help.

Many thanks in advance
Lisa

Cervenka Consulting Forums → ATENA → Error reading value → Post new reply