Back to company website

You are not logged in. Please login or register.

Forum updated

We have recently updated our forums system, and we have cleared all spam topics and users. In case we accidentally deleted your account, please register again. If you miss a topic you have posted before, please let us know.

Post new reply

Cervenka Consulting Forums → ATENA → About pull-out test → Post new reply

Post new reply

Compose and post your new reply

You may use: BBCode Smilies

All fields with bold label must be completed before the form is submitted.

Required information for guests


Required information

Topic review (newest first)

2 Post by dpryl

Dear zaherkurdi,
to setup the monitoring such that you can directly compare to a measurement, you first of all need to find out / explain how the measurement is executed in the experiment and how the slip and bond stress are calculated from the measured data.

Typically, one calculates the average slip and bond stress from reaction, bonded length, and some displacements difference.

Regards.

1 Post by zaherkurdi

Dear,

I use ATENA 3D to model pull-out test. Actually, I read ATENA Troubleshooting, 2.2.12 about pull-out test and everything ok. That I finished the model and after making running and finishing modelling I saw the cracks and the stresses and everything.
My question about the monitor point. Where I have to define the monitor points and what kind of the monitor points should I use? Because I am looking for the Bond stress - slip curve.
Please let me know about it.
Thank you.

Cervenka Consulting Forums → ATENA → About pull-out test → Post new reply