You are not logged in. Please login or register.

Forum updated

We have recently updated our forums system, and we have cleared all spam topics and users. In case we accidentally deleted your account, please register again. If you miss a topic you have posted before, please let us know.

Post new reply

Post new reply

Compose and post your new reply

You may use: BBCode Smilies

All fields with bold label must be completed before the form is submitted.

Required information for guests


Required information

Topic review (newest first)

1

Hello,

I am using ATENA Science 17.0.1 with GiD to model reinforced concrete half-joints with localised reinforcement corrosion.

My goal is to reduce the cross-sectional area of a reinforcing bar over a short length only (about 100–135 mm at the re-entrant corner), while the rest of the bar keeps its full area and the bond stays continuous along the whole bar.

As far as I understand, one polyline can only have one material, so I could not find a way to reduce the area over part of a bar. My workaround is to split the bar into three lines (start / short middle / end) and give the middle line a material with reduced AREA. Bond is defined with "bar with bond" (MC2010 bond-slip law).

My problem is the bar end setting. To transfer force across the joints I set the middle segment to "Fixed BOTH" and the neighbouring segments to Fixed START / Fixed END. I am worried that fixing the bar ends to the concrete at the joints restrains the slip and affects the results. In a check model where both ends of the beam had identical reinforcement (one end with split bars, the other with continuous polylines), the end with split bars behaved stiffer, and failure always occurred at the end with continuous bars.

Questions:
1. Is there a way to reduce the bar cross-section over only a short length of one bar, e.g. within a single polyline (similar to "Activate location dependency" for bond)?
2. Could "Activate corrosion dependency" (Acurr/Aorig) be used for this with a user-defined area loss, without the chloride transport model?
3. If splitting the bar is the only option, what is the recommended bar end setting so that the segments behave like one continuous bar?

Thank you very much for any advice.