You are not logged in. Please login or register.
Active topics Unanswered topics
Forum updated
We have recently updated our forums system, and we have cleared all spam topics and users. In case we accidentally deleted your account, please register again. If you miss a topic you have posted before, please let us know.
Post new reply
Post new reply
Compose and post your new reply
You may use: BBCode Smilies
All fields with bold label must be completed before the form is submitted.
Topic review (newest first)
Sending models to our webmaster is not the recommended way (it usually takes a few days before he forwards emails intended for someone else). The already referred instructions in Troubleshooting include the general support email address - that is the right one for question, bug reports, etc.
Hi there,
I was not sure how to send the file to you. I sent it to petr.branis gmail.com.
Please have a look and let me know.
regards,
Siavash
Hello, without seeing the models, we have no way to guess the reasons... Please send us both models following the instructions in ATENA Troubleshooting, 2.1.1 I have a problem not listed here.
Hi there,
I have two same models one with lower concrete compressive strength. The one with lower strength gives reasonable answer. However the one with higher strength interrupts due to "The execution is killed due to violation of stop iteration criteria". I checked the troubleshooting document but still doesn't make sense as the analysis for a stronger section does not converge for loads that the other model easily converged.
kind regards,
Siavash