Back to company website

You are not logged in. Please login or register.

Forum updated

We have recently updated our forums system, and we have cleared all spam topics and users. In case we accidentally deleted your account, please register again. If you miss a topic you have posted before, please let us know.

Post new reply

Post new reply

Compose and post your new reply

You may use: BBCode Smilies

All fields with bold label must be completed before the form is submitted.

Required information for guests


Required information

Topic review (newest first)

3 Post by Teresa

Dear Sir,

It is OK. Thank you!

Regards,
Teresa

2 Post by dpryl

Dear Teresa, I am afraid ATENA Engineering 3D users a special naming convention for it monitors, and it only recognizes monitors defined in the ATENA 3D Preprocessor. Please use AtenaWin (or AtenaConsole) to extract monitor values from models created in GiD or any other way.

1 Post by Teresa

Dear Sir,

I have a problem about the monitor results. I set up the model in GiD, and then imported the created inp file to ATENA 3D for calculation. But I can’t find any information about the defined monitor point during running process or in the postprocess in ATENA3D. But If I just use AtenWin to analyze the model built in GiD, the monitor points’ results can be found. My question is if the monitor information defined in GiD cannot be recognized by ATENA3D although the monitor definition is included in the inp file. Since I prefer to build up models in GiD and look at results in ATENA postprocess , I’d like to make sure this point with you. Thank you.

Regards,
Teresa