Back to company website

You are not logged in. Please login or register.

Forum updated

We have recently updated our forums system, and we have cleared all spam topics and users. In case we accidentally deleted your account, please register again. If you miss a topic you have posted before, please let us know.

Post new reply

Post new reply

Compose and post your new reply

You may use: BBCode Smilies

All fields with bold label must be completed before the form is submitted.

Required information for guests


Required information

Topic review (newest first)

4 Post by andreluison

Hi, actually, the monitor for point nearest IP node is working, but the monitor for point only is not. Is it the correct way to get the result?
here is the link for my model: https://drive.google.com/file/d/1BCtr5C … share_link

3 Post by mohamad.ahmad

Is your monitor in the first interval, is it monitor for reinforcement ?

Anyway can you please send your model to cervenka@cervenka.cz to check what is your mistake .

Thanks,
Mohamad

2 Post by pavlo

Can you share some screenshots from the pre-processor where you define the monitor and from the post-processor?

1 Post by andreluison

Hello, I was developing my beam model, which is a rebar -reinforced 4 point bending beam and I only model half span condition of the beam. So I was trying to measure the steel strain of the steel rebar at the mid span of the beam, but after running the analysis in atenastudio, the software didn't showed any result for the steel strain. The monitor for point I used is the strain and x direction. Anyone know what's wrong with that?

Thanks