• Tii
  • Member
  • Offline
  • Registered: 2013-04-15
  • Posts: 14

Topic: parametrization in ATENA-GID

Hello,

is there a possibility to parameterizes  a model which was created with the GID interface?
e.g.: I think of a circle for which I set the radius as a parameter so that its possible to change the circle just by giving the parameter an other value.

Quote Post 1

  • dpryl
  • CC software developer
  • Offline
  • Registered: 2007-07-13
  • Posts: 1,107

Re: parametrization in ATENA-GID

Dear Tii, I am afraid GiD does not support parametric modelling. I remember there was some option of recording your session creating the model, and re-runing it with modified values - please check the GiD menus and documentation.

You might also wish to look at SARA (especially the options of randomizing geometry).

dpryl's Website

Quote Post 2