• Registered: 2014-01-15
  • Posts: 9

Topic: error in 3D microelement generation

Hi there,

I tried to generate a few microelements next to each other forming a prism. First I introduced the surfaces and then extruded them. However it gave an error that more than 2 surface are connected to one edge. How can I solve it?

regards,
Siavash

Quote Post 1

  • dpryl
  • CC software developer
  • Offline
  • Registered: 2007-07-13
  • Posts: 1,107

Re: error in 3D microelement generation

Hello, please see ATENA Troubleshooting, section 3.3.2 Problem creating an opening (More than two surfaces are connected to the edge n.XX!). The latest version of the document is available from our web under http://www.cervenka.cz/products/atena/documentation/

dpryl's Website

Quote Post 2