• Dhiaa
  • New member
  • Offline
  • Registered: 2014-01-10
  • Posts: 5

Topic: Load cases error

Hello

I am using ATENA Engr 3D. I am applying a uniform pressure on a steel plate that is fully contacted with a concrete block. I defined it as a load case and specified its value and direction. When I hit Run, it gives me 'No load cases defined for this analysis step'. Do you have any idea what is the problem?

Regards,

Dhiaa

Quote Post 1

  • dpryl
  • CC software developer
  • Offline
  • Registered: 2007-07-13
  • Posts: 1,107

Re: Load cases error

Hello, I would guess the problem is exactly what the message says = you have not specified any load cases in the load step definition. Please see the ATENA Engineering 3D User's Manual, section 3.7.5.2 Analysis Steps.

We generally recommend new users to go through the ATENA Engineering 3D Tutorial before starting with your own model in ATENA 3D.

dpryl's Website

Quote Post 2