• From: Usa
  • Registered: 2017-03-30
  • Posts: 25

Topic: Force = zero

Hi,
I simulate a RC beam with discrete stirrups, without smeared rebars in ATENA 2D. After running, I saw the load-displacement diagram I found that the load (force) is always zero while displacement still increased, cracks still emerged !!!. So, could you give me some comments? Some wrongs in my works?
Thanks a lot.

Quote Post 1

  • dpryl
  • CC software developer
  • Offline
  • Registered: 2007-07-13
  • Posts: 1,107

Re: Force = zero

Dear Bikip, without seeing your model (Troubleshooting, 2.1.1) it is hard to guess what is wrong. I can only recommend to read ATENA Troubleshooting, 2.1.13 A monitoring point shows no value, the program gives me an error on reading a monitor value.

Regards.

dpryl's Website

Quote Post 2