• Registered: 2018-07-30
  • Posts: 1

Topic: Discrete reinforcement along R-Dir in Axial Symmetry

Dear all,

I'm simulating a axial symmetry of puncture test on cementitious composites. I would like to know that the spacing/interval of discrete line reinforcement along R-direction in 2D-ATENA default, because I couldn't define that spacing when I added the line reinforcement along R-direction in the models.

Thanks in Advance,
N.Kongwang

Quote Post 1

  • dpryl
  • CC software developer
  • Offline
  • Registered: 2007-07-13
  • Posts: 1,107

Re: Discrete reinforcement along R-Dir in Axial Symmetry

Dear N.Kongwang, you set the number of bars around the whole 360 degrees.
Regards.

dpryl's Website

Quote Post 2