• Registered: 2023-01-12
  • Posts: 4

Topic: Monitor for point

Hi, I was trying to match my 4-point bending model of the beam as the one on a research paper, however, It was not possible for me to monitor the result on a specific point, such as steel strain on the quarter span on a reinforcement and the concrete strain in the middle section of the beam. I believe that the monitor is based on the node from the mesh. what is the best way to obtain the correct measurement for this? I attached the picture of the model below.

https://drive.google.com/file/d/1GRtg-C … share_link
Regards,
Andre

Quote Post 1

  • Registered: 2020-09-07
  • Posts: 44

Re: Monitor for point

Just creat a point on the location where you want the monitor , then use the option 'monitor for the nearest point'
You can send us your model to cervenka@cervenka.cz

Regards,
Mohamad

Quote Post 2

  • Registered: 2023-01-12
  • Posts: 4

Re: Monitor for point

mohamad.ahmad wrote:

Just creat a point on the location where you want the monitor , then use the option 'monitor for the nearest point'
You can send us your model to cervenka@cervenka.cz

Regards,
Mohamad

Hi, I just want to ask if it is possible to measure the steel strain in the precise location, since the monitor for the nearest IP would measure the concrete strain if I'm not wrong

Quote Post 3