• Registered: 2009-10-12
  • Posts: 10

Topic: results

How do i get the report.....i mean a complete report of at which point there is max. deflection or the load of failure.
i m getting the graph the i need a report form. i m using ATENA 3D.

Quote Post 1

  • dpryl
  • CC software developer
  • Offline
  • Registered: 2007-07-13
  • Posts: 1,107

Re: results

I am not sure if I understand your question. The max. load is the peak of the Load-Displacement diagram.
The min.+max. values are always shown in the header of the graphical display/output. Look at the displacements iso areas to locate the maximum displacement. You can also monitor a max. or min. value of any quantity over all structure or a over a macroelement.

dpryl's Website

Quote Post 2