• Registered: 2012-10-16
  • Posts: 7

Topic: Arc &Circles

Hello.
for Create an arc I get following error :

Arc & circle parameters
Definition arc by center beg. (0.0570; 0.0000; 0.0570), end   (0.0000; 0.0000; 0.0000), center (0.0570; 0.0000; 0.0000), orientation positive
Division by angle every 10.00 °

The center of the arc is not between the first and last point!

how remove this problem.
tank you so much.

Quote Post 1

  • dpryl
  • CC software developer
  • Offline
  • Registered: 2007-07-13
  • Posts: 1,107

Re: Arc &Circles

Hello, I assume you work in ATENA Engineering 3D. Arcs are defined in working plane. Therefore, after you open the Macroelement creation/edit dialog, please first select your working plane and offset through the "Dialogue window for working plane and grid configuration" icon and the offset left of the icon.

dpryl's Website

Quote Post 2