1 Topic by apons3 (edited by apons3 2013-01-24 12:42:09)

  • Registered: 2013-01-24
  • Posts: 4

Topic: graphic/graphic parametres

I'm running with ATENA 3D. I would like to know what I should to do if after "RUN" I want to get a graph with the 'stress' (MPa) values in axis Y and the 'strain' in axis X, because I can only get a values of deflection, Load, conv. crit.1,2,3,4 in axis X and in axis Y the  unit values are m, MN, and [-].

IWhat should I do for get this kind of graph?

Thank you

Quote Post 1

  • dpryl
  • CC software developer
  • Offline
  • Registered: 2007-07-13
  • Posts: 1,107

Re: graphic/graphic parametres

Define the corresponding Monitoring Points - see ATENA 3D User's Manual, section 3.8.5.3 Monitoring.

dpryl's Website

Quote Post 2