• danzi
  • New member
  • Offline
  • Registered: 2013-02-21
  • Posts: 4

Topic: eroor message

Hi.

I have problems when I modeling a wall.I get an error message as follows:

CCFEmodelExc: The execution is killed due too violation of stop step criteria
                        Source line: 1150, file: ..\..\Sources\CCStructures\execute_model_load_step_AL_LS_method.cpp, last modified at : .... 


What I can see no material has exceeded it’s capacity (concrete, smeared reinforcement and rebars). The smeared reinforcement and rebars has a capacity of 347 MPa. The maximum crackwidth is 0,5388 mm at step 21. I have 24 steps. The problem is that Atena wan´t calculate the last tree step, any clues why?

Quote Post 1

  • dpryl
  • CC software developer
  • Offline
  • Registered: 2007-07-13
  • Posts: 1,107

Re: eroor message

Hello, please follow ATENA Trobleshooting, sections "2.2.2 I get the message "The execution is killed due to violation of stop iteration criteria", what does it mean?" and "2.2.5 Floating point problems - Division by zero, Loss of >7 digits on the matrix diagonal, Floating point exception: Multiple floating points traps, Zero or negative jacobian, InvertA: zero determinant, CCMaterials Extended AExc: CC5ParamYield F: project_stress_on_f_division by zero, and similar".

dpryl's Website

Quote Post 2