• ainn
  • New member
  • Offline
  • Registered: 2014-04-16
  • Posts: 2

Topic: cause of triangulation error

hello.
Im using 2D engineering ATENA. I would like to ask.
what is triangulation error? i tried to mesh my beam but it can't proceed.
Then i just proceed with next step by adding bar reinforcement & support. was it effect mesh's process?

Quote Post 1

  • dpryl
  • CC software developer
  • Offline
  • Registered: 2007-07-13
  • Posts: 1,107

Re: cause of triangulation error

Hello, problems with meshing are usually the consequence of wrong/inconsistent mesh settings, like trying to mesh a macroelement with many joints just 0.1mm apart with 10cm elements.
If you can not find the problem source, please send us the model (.cc3 file ZIPped) and
your ATENA User ID (WR) as instructed in ATENA Troubleshooting, 2.1.1.

dpryl's Website

Quote Post 2