• Registered: 2019-03-24
  • Posts: 7

Topic: Mesh Error

hello

Please I am asking about these errors after mesh

volume:
a point and a segment intersect.

Surface:
surface 0, line .... without elements

could I know what should I do please

Thank you for your time

Quote Post 1

  • dpryl
  • CC software developer
  • Offline
  • Registered: 2007-07-13
  • Posts: 1,107

Re: Mesh Error

Dear wajdi.mefleh,
1. please tell us which of the ATENA programs are you working with - I assume Engineering 3D?

2. Just guessing: If some points/lines are not part of any macroelement surfaces, they may just be source of problems during meshing. Although we have such an example of a monitoring point defined like this in the installation (Girder_wBars.cc3), however, is not recommended - if you change the mesh size such that no node coincides with the point, you get errors when meshing.

3. If you still can not find the problem source, follow ATENA Troubleshooting, 2.1.1 to send us your model etc.
The document is included in ATENA installation in PDF format and its current version is also available for separate download from our web (Products - ATENA - Documentation).

Best regards.

dpryl's Website

Quote Post 2

  • Registered: 2019-03-24
  • Posts: 7

Re: Mesh Error

good evening

sorry to send you again
but I fixed the errors and now I am keep having this error for a volume
volume:
a point and a segment intersect.

any ideas please
( I sent the model to the contacting e-mail )

Thank you again

Quote Post 3

  • Registered: 2019-04-05
  • Posts: 5

Re: Mesh Error

hello sir
i am working on RCC brick infilled  frame model with column size 100x100 mm, beam size 100x150mm and slab thickness 50mm. during meshing it gives a error showing below.

(x)    CCFEModelGenerateExc: T3D generator error code: 10
(x)    Internal error in mesh generator! Group 1 not generated.

please help me

Quote Post 4

  • dpryl
  • CC software developer
  • Offline
  • Registered: 2007-07-13
  • Posts: 1,107

Re: Mesh Error

Dear sandhu_balvir,
please first check if the reported volume group makes sense. Then, please follow ATENA Troubleshooting, 2.1.1 to send us your model etc.
Regards.

dpryl's Website

Quote Post 5