• Registered: 2019-05-21
  • Posts: 16

Topic: Difference in results

Hi

I’m using atena 3D to model continuous beam with two spans. I have a strange matter, because of having a symmetry beam, I model the half length for one span and got max deflection 35mm but when I model the total length, there is  a difference in results and got 20 mm deflection, noting the same conditions break criteria and the same error limit for both cases. So I hope to help me in that matter please, what are the reasons for that??

Thanks

Quote Post 1

  • From: Finland
  • Registered: 2019-03-28
  • Posts: 138

Re: Difference in results

Hi Ahmed,

You would better upload your model into a cloud and share link here. Otherwise no one can tell why you have such result smile

Quote Post 2

  • Registered: 2019-10-24
  • Posts: 6

Re: Difference in results

Dear Ahmed,
you can also follow Troubleshooting 2.1.1 and send us the model.

Best regards,
Michaela Vaitova

Quote Post 3