You are not logged in. Please login or register.
Cervenka Consulting Forums → ATENA → Beam Lap-Splice Analysis
Pages 1
Dear All
I am analyzing my beam under four pint bending. I failed to reach my desired results. I tried to figure out where i am doing something wrong but couldn't achieve.
Theoretical Failure Load = 54.9 KN
I need to validate my model in term of theoretical failure load.
I am attaching my model in below link
https://drive.google.com/open?id=1rPUjW … f9t5335VFS
Regards
Recently hasnat1947 was working on a very similar problem. You can find his posts on this forum.
Dear Ali,
1. please make clear how you plan to compare the calculate results with design formulas?
The most typical approaches with nonlinear FEM is working with mean properties and directly comparing to average measurements, or applying a global safety factor to prove safety.
2. Trying to constrain a nonexistant degree of freedom is a problem - please correct.
3. You may need a bond law for your model. The statement that you usually do not need it for ribbed reinforcement and fine meshes (Troubleshooting, 2.2.11) is mainly valid for 3D models - one can simply say in 2D, one dimension of your elements is the thickness, and this is usually much larger than the bar diameter.
Regards.
Thanks
I am using design option in ATENA, direct comparison with theoretical predictions could not be possible ?
If you explain us your plans, we may be able to help you find a way...
What kind of theoretical prediction do you wish to compare to?
What are the questions to be answered by your analysis (see also ATENA Troubleshooting, 2.1.1)?
I recommend the following articles on the safety formats topic:
https://www.cervenka.cz/assets/files/pa … rvenka.pdf
https://www.researchgate.net/publicatio … r_Analysis
Regards.
Thank you for the articles
Title of my study is "Numerical study of Tension Reinforcement Lap Length calculated by Model Code Using a Four-Point Beam Loading System"
1) In my current study i don't have any experimental campaign. To validate my model i am trying to compare the failure load given by software with theoretical failure load calculated based on sectional analysis.
Once model gives results almost accurate with theoretical in terms of failure load, I will carry out further study which is actually variation of splice length.
Regards
I understand you plan to follow MC2010 section 7.11 Verification assisted by numerical simulations, but have you already discussed the safety formats with your supervisor?
Ad 1.: Maybe you can find some publications with similar experiments, and verify / calibrate your model (modelling approach) using that?
I still do not get how you plan to compare with the design formula? The problem with partial safety factors is the failure mode can frequently be different than the real.
Regards.
Pages 1
Cervenka Consulting Forums → ATENA → Beam Lap-Splice Analysis
Powered by PunBB, supported by Informer Technologies, Inc.
