Topic: Stress on Interface is bigger than it can be?

Dear all.
I modelled two walls which are connected by a Z-connector, to connect the z connector to the walls I used an interface. The results in Atena show me that the stresses on the interface go up until +-200MPa, although in atena the cohesion for an interface is just 1MPa how is that possible?
Thank you a lot in advance.

Re: Stress on Interface is bigger than it can be?

Did you check Interface stress ? or what stress you activated in Studio ?
Can you please send your problem to Cervenka@cervenka.cz

Regards,
Mohamad