Topic: Errors with Atena 3d V4.2.7.5844
Hi there,
I recently installed the latest version of Atena 3D and was previously using Atena version 4.4. I have no problems opening version 4.4 files in the newer version. However when I try to analyse I get the following error:
"An internal error has occurred. Error identification as follows:
ID: A3Run_CalulateThread.pas/11
-Module: C:\PROGRA-2\CERVEN-1"
"error: Attempted to access an unnamed file past its end."
I have managed to solve this by remeshing. After re-meshing, the analysis commences but is interrupted by the following error and then stops:
(i) Analysis step 1
(!) Internal error during analysis monitoring: Invalid floating point operation
(!) Internal error while reading results: Access violation at address 04D74F34 in module 'A3Run_1.dll'. Read of address 00000058
(!) Internal error while reading results: Access violation at address 04D74F34 in module 'A3Run_1.dll'. Read of address 00000058
I have tried it using both USB and network licenses as well as using my colleagues computer and recieve the same error. Is there a current problem with opening models which were constructed with the older version in the latest version?
Regards
Robin