• Registered: 2012-10-16
  • Posts: 7

Topic: mesh

hello every one
I tried to mesh a  beam with opening with brick type but my macroelement mesh convert to tetra type.
I must divide beam to 4 part for meshing with brick type. how do it?
tanks a lot.

Quote Post 1

  • dpryl
  • CC software developer
  • Offline
  • Registered: 2007-07-13
  • Posts: 1,107

Re: mesh

Hello ssaber, you have to replace the Macroelement with the opening with several macroelements such that each of them is "brickable", i.e., has 6 four-edged faces. You can assign "mesh compatibility" to the artificial contacts between the MEs to have a compatible mesh throughout the original ME being replaced.

dpryl's Website

Quote Post 2